3. MaskRom mode¶
See startup mode for an introduction startup mode
MaskRom pattern is the last line of defense equipment burn out. Forced entry MaskRom involved hardware operation, have certain risk, so only in the equipment into the Loader mode, can try MaskRom mode.
Please read carefully and operate carefully!
The operation steps are as follows:
Disconnect the power supply of the device
Use tweezers to short the two test points on C40PL (both as shown in the figure below)
Plug the device into the power supply and power it on
The following are the two test points on C40PL

At this point, the device should go into MaskRom mode.
