UART¶
Introduction¶
AIO-1684XQ supports 3 UART devices:
Device name | Interface function | Baud rate | Full duplex | Level |
---|---|---|---|---|
/dev/ttyS0 | Debug serial port | 115200 | yes | TTL |
/dev/ttyS1 | RS485 | 9600 | No | RS485 |
/dev/ttyS2 | RS485 | 9600 | No | RS485 |
The RS485 interfaces diagram of AIO-1684XQ board is as follows:
Debug¶
Users can use different host’s USB-to-serial adapters to send and receive data to the serial port of the development board according to different interfaces. For example, the debugging steps of RS485 are as follows:
(1) Connecting the hardware
Connect the RS485B-A, RS485B-B and GND of the development board to the A, B and GND pins of the host serial adapter (USB to 485 to serial port module) respectively.
(2) Open the serial terminal of the host
Open kermit in the terminal and set the baud rate:
$ sudo kermit
C-Kermit> set line /dev/ttyUSB0
C-Kermit> set speed 9600
C-Kermit> set flow-control none
C-Kermit> connect
/dev/ttyUSB0
is the device file of the USB-to-serial adapter
(3) Send data
The device file for RS485 is /dev/ttyS2
. Run the following commands on the device:
sudo -s
stty -F /dev/ttyS2 9600 -echo
echo firefly RS485 test... > /dev/ttyS2
The serial terminal in the host can receive the string “firefly RS485 test…”
(4) Receive data
First run the following command on the device:
sudo -s
cat /dev/ttyS2
Then enter the string “Firefly RS485 test…” in the serial terminal of the host, and the same string can be seen on the device side.