Login

There are two ways to log in to EC-Orin NX: one is through Type-C, and
the other is via network SSH.

Type-C

For the Type-C login method, users can directly refer to the AIO-
OrinNX wiki page's section on "

Using Type-C Serial Debugging

," with the login username and password both being "linaro".

Ethernet SSH

EC-Orin NX has two Ethernet ports. By default, at the factory, port 0
(near the USB connector) is set to dynamic IP, while port 1 (near the
HDMI port) is set to static IP "192.168.150.1" with a subnet mask of
"255.255.255.0". You can set the PC to "192.168.150.2/24" for the
initial login.

Port 0 has its IP assigned by a router, and the IP address information
is generally not known beforehand, so it is best for the user to
choose port 1 for the initial login.

After the port light is flashing normally, open a terminal and use
"ssh" to log in, with the port number being "22", and the username and
password also being "linaro":

   ssh linaro@192.168.150.1

If the login fails, you can try to see if the PC can "ping" the IP
address of EC-Orin NX's port 1. Note that the PC must have an IP in
the same subnet, as the PC's IP address may not necessarily be in the
same subnet.

Here are the methods for adding a same-subnet IP on the PC (using
administrator mode):

Windows 10  netsh int ipv4 add address "Ethernet" 192.168.150.101
255.255.255.0  Here, "Ethernet" refers to the network interface,
192.168.150.101 is the IP address, and 255.255.255.0 is the subnet
mask.

Linux  ifconfig enp4s0:1 192.168.150.89  Here, enp4s0 is the network
card driver name of the PC, which can be checked by executing the
ifconfig command.