U-Boot

Introduction

RK U-Boot based on the open source U-Boot development, work mode has a
Boot loading mode and download mode. Boot load mode is the normal
working mode of u-boot, embedded product release, u-boot is working in
this mode, mainly used for Boot to load the memory of the kernel into
memory, start the operating system; Download mode is mainly used to
download the firmware to flash memory, and press the Recovery button
to enter the download mode after startup time. This article briefly
explains the use of u-boot. Please refer to the development document

Uboot Development

.

Compile

The compiling steps of U-Boot are similar to kernel compiling. Before
compiling, you need to write the configuration to ".config", run the
command:

Android:

   make rk3568_defconfig

Linux:

   make firefly_rk3568

If you need to modify the relative option, you can run:

   make menuconfig

Run below command to compile:

   make ARCHV=aarch64

After compiling successfully, there will be a new file created at the
follow path:

   u-boot/uboot.img
   u-boot/trust.img
   u-boot/rk356x_spl_loader_v1.05.108.bin

Flash Image

Open the upgrade tool, connect the board with the USB OTG cable, press
the Recovery key when the power is on, and make the development board
enter the U-Boot download mode. Select the compiled Loader file in the
upgrade tool and click execute, as shown below:


Verify that the new Loader is correctly upgraded

If you flash the loader successfully, there will be some information
output from the debug UART as the follow log shows:

   Android 11.0, Build 2021.2, v2

If the time shows the same as your compile time, it means you flash
the loader successfully.

Enter u-boot command line mode

When the system starts, long press "ctrl+c" through the debugging
serial port to enter the u-boot command mode

   => <INTERRUPT>
   => <INTERRUPT>
   =>
   => help
   ?       - alias for 'help'
   android_print_hdr- print android image header
   base    - print or set address offset
   bdinfo  - print Board Info structure
   bidram_dump- Dump bidram layout
   boot    - boot default, i.e., run 'bootcmd'
   boot_android- Execute the Android Bootloader flow.
   boot_fit- Boot FIT Image from memory or boot/recovery partition
   bootavb - Execute the Android avb a/b boot flow.
   bootd   - boot default, i.e., run 'bootcmd'
   bootefi - Boots an EFI payload from memory
   booti   - boot arm64 Linux Image image from memory
   bootm   - boot application image from memory
   bootp   - boot image via network using BOOTP/TFTP protocol
   bootrkp - Boot Linux Image from rockchip image type
   bootz   - boot Linux zImage image from memory
   cmp     - memory compare

The secondary Loader

RK3568 uses a secondary Loader. The generated image is:

   u-boot/uboot.img
   u-boot/rk356x_spl_loader_v1.05.108.bin

Where 'V1.05.108' is the release version, Rockchip defines the version
of the u-boot loader,Where '1.05.108' is defined according to the
storage version and must not be modified by the customer.'uboot.img'
contains the uboot firmware.